A C-type centrifugal fan for light dust, wood chips, sawdust, fine fibers and similar loose particles selected from the complete dust collection operating point rather than from model name alone.
Selection should confirm capture airflow, complete system resistance, particle condition, fan position, rotation and outlet direction before the final fan size and motor are fixed.
Start with Dust, Airflow, Resistance and Fan Position
C6-48 selection should follow the real dust collection duty. A known model number is not enough if the capture airflow, filter resistance, particle condition or installation route has changed.
Dust Type
Wood chips, light sawdust, fine fibres, textile dust and similar low-abrasion particles.
Airflow
Confirm hood demand, active branches, duct velocity and the required design airflow.
Pressure
Include ducts, elbows, dampers, separators, baghouse filters and outlet loss.
Installation
Check fan position, rotation, outlet angle and site access before production.
Place the C6-48 Inside the Complete Dust Handling Route
Fan wear and real operating pressure depend on what happens before and after the fan, not only on the fan itself. For full system planning, review the Industrial Dust Collection System.
Suitable Direction vs Separate Engineering Review
Light and Low-Abrasion Dust
Fine fibres and textile dust
Workshop dust exhaust
Reduced-dust airflow after separation
Replacement projects with known data
Abrasive, Sticky or Hazardous Dust
Metal particles or strongly abrasive dust
Sticky, wet or viscous material
High-temperature or corrosive gas
Combustible dust or explosion-risk conditions
C6-48 Preliminary Performance Range
The existing data is retained for preliminary reference. Final selection must be checked against the real operating point, performance curve, dust condition and motor configuration.
Rotation, Outlet Angle and C-Type Transmission
Rotation and Outlet Angle
Clockwise rotation from the transmission side is marked as right-hand rotation; counterclockwise rotation is left-hand rotation.
Typical outlet positions include 0°, 45°, 90°, 135°, 180° and 225°.
Impeller and C-Type Drive
The impeller handles dust-laden airflow. Hard particles require separate wear and inlet-protection review.
C-type belt drive includes shaft, bearing box, pulley and related components.
Typical Dust Collection Duties
Wood Chip Exhaust
Light wood chips and sawdust after transport route and inlet protection are reviewed.
Fibre Dust Removal
Fine fibres and light dust from textile and fibre-processing equipment.
Workshop Dust Exhaust
Dust-laden workshop airflow with known capture demand and system resistance.
Reduced-Dust Exhaust
Collector or separator outlet conditions where the dust load has been reduced.
Light Particle Collection
Loose particles after dust hardness, concentration and fan position are checked.
Replacement Review
Projects with an old nameplate, drawing or measured operating-point data.
Continue from C6-48 to System Selection
C6-48 Dust Collection Fan FAQ
What is the C6-48 typically used for?
Light wood chips, sawdust, fine fibres and similar loose, low-abrasion particles.
Can it handle cement or mineral dust?
Not automatically. Abrasive mineral dust requires separate wear and pre-separation review.
Does particle size affect selection?
Yes. It affects transport velocity, separation efficiency, inlet protection and wear risk.
Should a collector be installed before the fan?
For hard or abrasive particles, pre-separation should normally reduce the load before the fan inlet.
Which pressure value should be supplied?
State static pressure or total pressure and include the complete system resistance.
What should be sent for quotation?
Airflow, pressure, dust properties, temperature, duct layout, fan position, outlet angle, voltage and quantity.
Send the Operating Point + Dust Condition
Share airflow, pressure, dust type, particle size, hardness, concentration, temperature, duct layout, fan position, outlet angle, rotation, voltage and quantity.
Tel / WeChat / WhatsApp: +86 15653305981 | Email: sales@qiyuefan.com
Hot Tags: c6-48 dust collection centrifugal fan, China c6-48 dust collection centrifugal fan manufacturers, suppliers, factory
